Your Ethernet network, 172.30.1.0, shuts down. Which update message is seen in your router's debug ip
rip output regarding that network?
A -
Subnet 172.30.1.0, metric 0
B -
Subnet 172.30.1.0, metric 1
C -
Subnet 172.30.1.0, metric 15
D -
Subnet 172.30.1.0, metric 16
2-
Which command displays the configuration register setting?
A -
Show register.
B -
Show flash.
C -
Show boot this IOS command displays the settings of the boot environment variables.
D -
Show version.
3-
When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be
configured?
A -
The Frame Relay encapsulation on the physical interface.
B -
The local DLCI on each subinterface.
C -
An IP address on the physical interface.
D -
The subinterface type as point-to-point.
4-
Which IOS command is used to associate an ISDN phone number with the next hop router address?
A -
Isdn destination number.
B -
Dialer map.
C -
Isdn spid1.
D -
Isdn line number.
5-
Use the partial BRI configuration and graphic shown. Which additional command must be issued on the
Central router before interesting traffic will be sent to the Remote router?
A -
(config-if)# dialer-group 1
B -
(config-if)# dialer-list 1
C -
(config-if)# dialer map 1
D -
(config-if)# dialer-route 1
6-
Router A is connected to Router B, a non-Cisco router, through the network cloud. Using the command
output shown what must be configured on Router A's interface s0 to change the line protocol from down
to up?
A -
No shutdown.
B -
Encapsulation ppp.
C -
Interface serial point-to-point.
D -
Clock rate 56000.
7-
Which Frame Relay feature allows the point-to-point Frame Relay PVC between Router A and Router B
to be identified at Router A as 100 and at Router B as 200?
A -
Locally significant DLCI
B -
Globally significant DLCI
C -
Locally significant LMI
D -
Globally significant LMI
8-
During encapsulation in which order is information packaged?
A -
Data, Packet, Segment, Frame.
B -
Segment, Data, Packet, Frame.
C -
Data, Segment, Packet, Frame.
D -
Packet, Data, Segment, frame.
9-
What is the Layer 2 address as shown in the output of the show ipx interface e0 command?
A -
0000.0c
B -
5d.b35e
C -
0c5d.b363
D -
0000.0c5d.b363
10-
Which devices operate at all seven layers of the OSI model? (Choose three.)