Which three statements about common elements of the TCP/IP protocol stack are true?
A -
IP provides connection less service and routing capabilities.
B -
UDP provides simple connection less service without windowing or acknowledgements.
C -
TCP enables devices to send large quantities of data using switching in a connection-oriented manner.
D -
All of the above.
2-
Using the TCP/IP suite a message is sent from host A to a destination IP address on the same LAN. How
does host A determine the destinations MAC address?
A -
It uses a Proxy ARP.
B -
It uses ARP requests.
C -
It uses RARP requests.
D -
It uses router look up table.
3-
What is the two most common request/reply pair with ICMP messages when using the ping command?
A -
Echo reply
B -
Echo request
C -
Source quench
D -
Both A & B
4-
Which two protocol tools use ICMP?
A -
Ping
B -
Trace route
C -
Configure
D -
Both A & B
5-
Which command successfully ping an individual IP address?
A -
Router>ping 192.5.5.0
B -
Router# ping 192.5.5.30
C -
Router> ping 192.5.5.256
D -
Router# ping 192.5.5.255
6-
Your network uses a class C address of 210.10.10.0 you must now split up the network into separate
subnets to handle multiple buildings separated by router. Which two steps must you take to determine
the proper subnet mask for your network?
A -
Determine how many devices will require DHCP addressing.
B -
Determine the number of separate networks required.
C -
Determine the maximum number of host that will be on each subnet.
D -
Both B & C
7-
How many collisions are caused by transmitting and receiving frames simultaneously in a full-duplex
Ethernet Technology?
A -
One
B -
Two
C -
None
D -
Several
8-
Which Cisco IOS command should you use to display the Novel IPX address assignments on a router?
A -
Show IPX addresses.
B -
Show IPX interface.
C -
IPX network <number>
D -
Display IPX addresses
9-
Which commands should you use to enable IGRP routing?