Which keystroke allows IOS to complete a partial command entry?
A -
<Tab>
B -
<Ctrl R>
C -
<Spacebar>
D -
<Right Arrow>
2-
Eight stations connected to separate 10Mbps ports on a layer 2 switch will give each station how many
Mbps of bandwidth?
A -
1.25
B -
4
C -
16
D -
10
3-
Which two WAN data link layer protocols support multiple upper layer protocols?
A -
PPP
B -
HDLC
C -
ISDN
D -
Both A & B
4-
Which command enables directly connected network 199.55.72.0 to be used by RIP?
A -
Router(Config)# rip 199.55.0.0
B -
Router(Config-router)# network 199.55.72.0
C -
Router(Config-router)# network 199.55.0.0
D -
Router(Config-router)# rip 199.55.72.0
5-
What does the command show access-list 101 list?
A -
The contents of extended access list 101
B -
All access lists within the router.
C -
The contents of standard access list 101
D -
All extended access lists.
6-
Which two commands show your access lists?
A -
Show access-lists.
B -
Show IP access-list.
C -
Show running-Config.
D -
Both B & C
7-
Which statement about the Point-to-Point protocol (PPP) is true?
A -
PPP supports TCP/IP, but not Novell IPX.
B -
PPP is being phased out of existence by the Serial Line Internet protocol.
C -
PPP provides router-to-router and host-to-network connections over both synchronous and asynchronous circuits.
D -
PPP is an ITU-T and ANSI standard that defines the process for sending data over a packet-switched data network.
8-
Which encapsulation methods are most commonly used with dialup integrated services Digital Network
(ISDN)?
A -
IP and IPX
B -
IP and PPP
C -
PPP and SDLC
D -
PPP and HDLC
9-
Which two steps are parts of the process of creating Frame Relay subinterfaces on a point-point
connection?
A -
Configure the router to forward all broadcast packets.
B -
Remove any network address assigned to the physical interface.
C -
Configure the local data-link connection identifier for the subinterfaces.
D -
Both B & C
10-
Your network is having IP problems connecting to one or more Frame Relay peer routers. Which two
commands should you use to show the routers that are reachable?