Assuming no subnetting, which two pieces of information can be derived from the IP address
144.132.25.10?
A -
It is a Class C address
B -
It is a Class B address
C -
The host portion of the address is 25.10
D -
Both B & C
3-
Given the following criteria for granting access from a remote site to your LAN :
restrict access on interface E0
E0=128.12.22.55
Deny access to telnet, FTP
All other types of operations.
Which line should come last in configuring your access list?
A -
Access-List 101
B -
Access-List 101 deny E0 telnet FTP
C -
Access list 101 allow all except FTP telnet
D -
Access list 101 permit IP 0.0.0.0 255.255.255.255 any
4-
Which configuration task must you complete if a remote Frame Relay Router does not support Inverse
ARP?
A -
Configure static maps.
B -
Define an IP address.
C -
Disable DHCP on the Frame Relay router.
D -
Configure a static route to the remote network.
5-
You are configuring a Frame Relay Router with subinterfaces on interface Serial 0. Which subinterface
number could you use for this configuration?
A -
1 and 2.
B -
0.2 and 0.3
C -
1 and 1.1
D -
0.1a and 0.1b.
6-
What is the total bandwidth of all channels on a BRI circuit?
A -
64 kps
B -
112 kps
C -
128 kps
D -
144 kps
7-
Company XYZ has an employee that works out of the home. The employee runs big client-server
applications and must quickly transfer large files. The company wants the best cost/benefit on this
connection. What would be the most practical solution?
A -
An ISDN basic rate interface (BRI) connection to the users home.
B -
A dedicated T1 connection to the users home.
C -
A dedicated Frame Relay connection to the users home.
D -
A standard 28.8 analogue dial up connection to the users home
8-
What does the Frame Relay switch use to distinguish between each PVC connection?
A -
Data link connection identifier (DLCIs)
B -
CNs
C -
FECNs
D -
Local management interface LMI
9-
You telnet to a host on a remote network. Which MAC address will be present in the ARP table when
you issue the show arp command?
A -
MAC address of the destination router Serial port.
B -
MAC address of the destination host Ethernet port.
C -
MAC address of the local router Ethernet port.
D -
MAC address of the local router Serial Port.
10-
Which three pieces of CDP information about neighboring routers are displayed on your console
terminal?