Refer to the exhibit. Which three statements are true about how router JAX will choose a path to
the 10.1.3.0/24 network when different routing protocols are configured?
A -
By default, if RIPv2 is the routing protocol, only the path JAX-ORL will be installed into the routing table.
B -
When EIGRP is the routing protocol, the equal cost paths JAX-CHI-ORL, and JAX-NY-ORL will be installed in the routing table by default.
C -
With EIGRP and OSPF both running on the network with their default configurations, the EIGRP paths will be installed in the routing table.
D -
All of the above
2-
Refer to the exhibit. Which three statements correctly describe Network Device A?
A -
With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet.
B -
With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate with each other.
C -
With a network wide mask of 255.255.254.0, each interface does not require an IP address.
D -
All of the above
3-
On the basis of the IEEE 802.1w standard, which two switch ports can forward traffic?
A -
alternate
B -
backup
C -
designated
D -
disabled
4-
Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely
reason that interface FastEthernet 0/10 is not the root port for VLAN 2?
A -
This switch has more than one interface connected to the root network segment in VLAN 2.
B -
This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.
C -
This switch interface has a higher path cost to the root bridge than another in the topology.
D -
This switch has a lower bridge ID for VLAN 2 than the elected designated switch.
5-
Refer to the exhibit. The network administrator must establish a route by which London
workstations can forward traffic to the Manchester workstations. What is the simplest way to
accomplish this?
A -
Configure a dynamic routing protocol on Manchester to advertise a default route to the London router.
B -
Configure a static default route on London with a next hop of 10.1.1.1.
C -
Configure a static route on London to direct all traffic destined for 172.16.0.0/22 to 10.1.1.2.
D -
Configure Manchester to advertise a static default route to London.
6-
Refer to the exhibit. This command is executed on 2960Switch: 2960Switch(config)# mac-address-table static 0000.00aa.aaaa vlan 10 interface fa0/1
Which of the statements correctly identify results of executing the command?
A -
Port security is implemented on the fa0/1 interface.
B -
MAC address 0000.00aa.aaaa does not need to be learned by this switch.
C -
Only MAC address 0000.00aa.aaaa can source frames on the fa0/1 segment.
D -
Frames with a Layer 2 source address of 0000.00aa.aaaa will be forwarded out fa0/1.
7-
Which of the following describes the roles of devices in a WAN?
A -
A CSU/DSU terminates a digital local loop.
B -
A modem terminates an analog local loop.
C -
A router is commonly considered a DTE device.
D -
All of the above
8-
What are two characteristics of Telnet?
A -
It sends data in clear text format.
B -
It is no longer supported on Cisco network devices.
C -
It is more secure than SSH.
D -
It requires an enterprise license in order to be implemented.
9-
Which two security appliances will you use in a network?
A -
ATM
B -
ids
C -
ios
D -
iox
10-
A single 802.11g access point has been configured and installed in the center of a square office. A
few wireless users are experiencing slow performance and drops while most users are operating
at peak efficiency. What are three likely causes of this problem?