Which of the following are true? A. The default is to send debug output to the console screen. B. To view debug output from a telnet session, the "terminal monitor" command must be used. C. If the "logging buffered" command is used, the debug output would be sent to RAM and can be viewed with the "show log" command. D. If the "no console logging" command were configured, output would be sent to a telnet session. E. All of the above...... What is a benefit of a virtual LAN (VLAN)? A. It increases the number of broadcast domains. B. It decreases the number of broadcast domains. C. It increases the number of collision domains. D. It decreases the number of collision domains.....

What are four benefits that can result from applying ISDN networking?(Choose four) A. Full time connectivity across the ISDN supported by Cisco IOS routing using dial on demand routing DDR. B. Small office and home office sites can be economically supported with ISDN basic rate interface BRI services. C. ISDN replaces signaling system ss7 in the public switch telephone network PSTN backbone. D. ISDN can be used as a backup service for a lease line connection between the remote and central offices. E. Modem racking and cabling can be eliminated by integration with digital modem cards on Cisco IOS network access servers NAS........

Given the network 199.141.27.0 with a subnet mask of 255.255.255.240, identify the valid host addresses. A. 199.141.27.33 B. 199.141.27.112 C. 199.141.27.119 D. 199.141.27.126 E. 199.141.27.175 F. 199.141.27.208..... The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses. What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum. Type the correct value in each box below.....

What are the effects of sustained, heavy collisions in CSMA/CD LANs? (Choose three.) A. Increased broadcast traffic. B. Delay. C. Low throughput. D. High throughput. E. Congestion. F. Higher bandwidth.... Modem networks are often described as using 100Base-TX components. What is meant by the term 'Base' in this definition? A. It describes the signaling method for communication on the network. B. It refers to the type of media used in the network. C. It relates to the speed of transmission of network signals. D. It defines the allowable length of media that can be used. E. It defines half-duplex or full-duplex operation.....

With the hierarchical numbering of IP addresses what determines the portion of the address that will identify the network number? A. Subnet Mask. B. Dots between octets. C. Class of first octet. D. Assignments of DHCP. E. Address Resolution Protocol...... At which OSI layer does data translation and code formatting occur? A. Physical B. Data link C. Network D. Transport E. Session ..... A:The physical layer is what puts the actual data onto the wire. B:The data link layer is involved in converting bits into bytes, converting bytes into frames and with error detection.....

Your Ethernet network, 172.30.1.0, shuts down. Which update message is seen in your router's debug ip rip output regarding that network? A. Subnet 172.30.1.0, metric 0 B. Subnet 172.30.1.0, metric 1 C. Subnet 172.30.1.0, metric 15 D. Subnet 172.30.1.0, metric 16..... Which command displays the configuration register setting? A. Show register. B. Show flash. C. Show boot this IOS command displays the settings of the boot environment variables. D. Show version...... The show version command displays version information for the hardware and firmware. This includes the register settings.....