To view debug output from a telnet session, the "terminal monitor" command must be used.
B -
If the "logging buffered" command is used, the debug output would be sent to RAM and can be viewed with the "show log" command.
C -
If the "no console logging" command were configured, output would be sent to a telnet session.
D -
All of the above.
2-
What is a benefit of a virtual LAN (VLAN)?
A -
It increases the number of broadcast domains.
B -
It decreases the number of broadcast domains.
C -
It increases the number of collision domains.
D -
It decreases the number of collision domains.
3-
IP RIP routing is configured on a router, but all interfaces attach to RIP network. What should you use
to prevent all RIP routing updates from being sent through selected interfaces without using access lists?
A -
Passive route.
B -
Default routes.
C -
Passive interface.
D -
Route update filtering.
4-
What are two characteristics of the RARP protocol?
A -
It maps IP addresses to Ethernet addresses.
B -
It maps Ethernet addresses to IP addresses.
C -
It is implemented directly on top of the data link layer.
D -
Both B & C
5-
What must you do to test connectivity on a dial-on-demand routing (DDR) link?
A -
Increase the idle timeout parameter.
B -
Send interesting traffic across the link.
C -
Reboot one of the Integrated Services Digital Network (ISDN) routers.
D -
Reset the DDR Integrated Services Digital Network (ISDN) router statistics to zero.
6-
Which element is used to define the rate, in bits per second, that a Frame Relay switch agrees to transfer
data?
A -
Clock rate (CR).
B -
Committed Information Rate (CIR)
C -
Local management interface (LMI)
D -
Data-link connection identifier (DLCI)
7-
Which term describes the process in which frames from one network system are placed inside the frames
of another network system?
A -
Bridging.
B -
Data-link control.
C -
Tunneling.
D -
Generic routing.
8-
What is the protocol and what is the purpose of the following address?
238.255.255.255
A -
IP; a multicast address.
B -
IPX; a SAP broadcast.
C -
IP; a reserved address.
D -
IP; a directed broadcast.
9-
Given the configuration example:
interface ethernet0
ipx network 4a
ipx access-group 800 out
interface ethernet1
ipx network 3d
interface ethernet2
ipx network tc
access-list 800 permit 3d 4a
Which two actions result from implementing this configuration?
A -
Traffic from network 3d for network 3d will be forwarded out e0.
B -
Traffic from network 3d, destined for network 4a, will be forwarded out e2.
C -
The access list is applied to an outgoing interface and filters outbound traffic.
D -
Both B & C
10-
Which show interface serial 1 status statement indicates that the shutdown command was issued on that
interface?
A -
Serial 1 is up, line protocol is up.
B -
Serial 1 is up, line protocol is down.
C -
Serial 1 is down, line protocol is down.
D -
Serial 1 is administratively down, the line protocol is down.