You have decided to remove RIP routing on your router and install IGRP. You have issued the command no router rip on all of your routers. You now need to install IGRP on your routers. Which commands should you use to enable IGRP routing? A. router igrp 100 network 192.168.1.0 network 10.0.0.0 B. router igrp 100 network 192.168.1.0 network 10.2.0.0 C. router igrp 100 network 192.168.1.0 192.168.1.1 network 10.2.0.0 10.2.1.1 D. router igrp 100 network 192.168.1.0 255.255.255.0 network 10.2.0.0 255.255.0.0.....

Your company has decided to use a (BRI) connection between the Florida office and the Georgia office. You would like to configure dial on demand routing (DDR) on this connection. Which of the following commands are required to setup DDR? A. Define static routes. B. Configure the dialer information. C. Specify interesting traffic that can enable the link. D. Define DDR password to exchange when the link comes up..... For security reasons you would like a system message displayed when logging into a router. Which of the following allows you to create this message? A. Banner MOTD B. Message MOTD C. Banner Message....

You are using two back-to-back serial cables in your test lab between two Cisco routers. You have determined that one of these routers is the DCE by using the show controllers command. You now need to configure the clock rate to 64 Kbps on serial0 which one of the following commands will allow you to do this? A. Clockrate 64 B. Clock rate 64 C. Clockrate 64000 D. Clock rate 64000 E. Set clockrate 64 F. Serial 10 clockrate 64 G. Clock rate 64000 serial 10

Which one of the following statements about an Ethernet LAN is true? A. The advantage of a full duplex is the ability to transmit data over Mbase2 cable. B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present. C. Ethernet switches can use full duplex mode to connect multiple nodes to a single port of a switch. D. Half duplex is a cut through packet processing method that is very fast with little error correction, full duplex is store and forward method that is slower but has better error correction......

You have just created an IP extended access list and now wish to apply this to an interface. Which command will allow you to apply the list to an interface? A. Permit access-list 101 out B. Ip access-group 101 out C. Apply access-list 101 out D. Access-class 101 out E. Ip access-list e0 out... A publishing company has three routers in their network. Marshal, Sherman, and Patton. The Marshal and Sherman routers are fully configured. The Patton router is also fully configured, but need to have a password for the first 5 virtual lines, password for console, and an encrypted password for privileged mode......

Which are the following are considered ISDN benefits? A. Full time connectivity across the ISDN supported by Cisco IOS routing using dial on demand routing DDR. B. Small office and home office sites can be economically supported with ISDN basic rate interface BRI services. C. ISDN replaces signaling system ss7 in the public switch telephone network PSTN backbone. D. ISDN can be used as a backup service for a lease line connection between the remote and central offices. E. Modem racking and cabling can be eliminated by integration with digital modem cards on Cisco IOS network access servers NAS......

#debug ppp authentication ppp serial1: send CHAP challenge id-47 t remote ppp serial1: CHAP challenge from TestK ppp serial1: CHAP response received from TestK ppp serial1: CHAP response id=47 received from TestK ppp serial1: Send CHAP success id=47 to remote ppp serial1: Remote passed CHAP authentication ppp serial1: Passed CHAP authentication ppp serial1: Passed CHAP authentication with remote You issued the command debug ppp authentication what type of handshaking was used for this PPP session? A. One-way B. Two-way C. Three-way.....

You have issued the show ip route command and looking at the routing table entry, which of the following are used by default in the calculation of the number 8675309? I 131.107.0.0 [100/8675309] via 192.168.16.3, 00:00:55, Ethernet0 A. MTU B. Bandwidth C. Administrative distance D. Hop count E. Metric F. Delay........ You have typed the command clock on a Cisco router and pressed enter/return you received "% INCOMPLETE COMMAND" response from a Cisco CLI. How can you receive help on this command? A. Type "history" to review the prompt before the error. B. Enter a question mark to display all console commands. C. Type "help" followed by the command to see the command parameter........

You are unable to connect to the company’s local tftp server using the IP address 10.0.0.20 from your personal computer. You would to test your personal computer to make sure the TCP/IP has been corrected installed. Which one of the following actions will allow you to test the protocol stack on your personal computer? A. Ping 127.0.0.0 B. Ping 203.125.12.1 C. Telnet 127.0.0.1 D. Ping 127.0.0.1 E. Tracert 203.125.12.1..... Users on your network 10.1.0.0/16 are complaining that they cannot access the company’s intranet server using the FQDN www.snowball.com. You are able to ping the IP address but you cannot ping www.snowball.com. What is the likely cause of this problem?....

In your test environment you are connecting two routers together using a back-to-back serial cable. You are not using DSU/CSUs between these devices. Which additional command must be used to be able to establish this connection between these two routers on the router acting as the DCE? A. Serial up. B. Line protocol up. C. Clock rate. D. Dce rate. E. Dte rate...... If Ctrl-p recalls the previous command line what does the up arrow key provide within the Cisco IOS? A. Recalls the previous command line. B. Moves the cursor one line up. C. Redisplays the current command line.....