You have issued the show ip route command and looking at the routing table entry, which of the
following are used by default in the calculation of the number 8675309?
I 131.107.0.0 [100/8675309] via 192.168.16.3, 00:00:55, Ethernet0
A -
Administrative distance
B -
Hop count
C -
Metric
D -
Delay
2-
You have typed the command clock on a Cisco router and pressed enter/return you received "%
INCOMPLETE COMMAND" response from a Cisco CLI. How can you receive help on this command?
A -
Type "help" followed by the command to see the command parameter.
B -
Re enter the command followed by question mark to view key words.
C -
Enter a question mark to display all console commands.
D -
Type "history" to review the prompt before the error.
3-
What does ISL trunking protocol use to identify the VLAN membership of a frame over trunked links?
A -
Frame filtering with VLAN ID
B -
Frame filtering with trunk ID
C -
Frame tagging with VLAN ID
D -
Frame tagging with trunk ID
4-
To configure information into RAM on a router which three commands can be used?
A -
Configure memory.
B -
Configure terminal.
C -
Copy startup-Config running-Config.
D -
All of the above
5-
Using the address 192.64.10.0/28 how many subnets and hosts are available?
A -
16 networks and 16 hosts
B -
14 networks and 14 hosts
C -
8 networks and 32 hosts
D -
6 networks and 30 hosts
6-
The network 131.107.4.0/24 was advertised by a neighbor router from RIP and IGRP. You also added a
static route to 131.107.4.0/24 manually. Which route would be used to forward traffic?
A -
The IGRP route.
B -
The RIP route.
C -
The static route.
D -
All three will load balance.
7-
You just purchased a new router from Cisco and now are in the process of installing it. Upon boot up the
router enters the setup mode. You are prompted to enter the enable password and the enable secret
password. What is the difference between the two passwords?
A -
The enable secret password cannot be seen as clear text when viewing the configuration.
B -
The enable secret password uses IPSec password authentication.
C -
The enable password is encrypted.
D -
The enable secret password acts as a backup in case the enable password is compromised.
8-
What is the broadcast address for this network 192.57.78.0/27?
A -
192.57.78.64
B -
192.57.78.87
C -
192.57.78.97
D -
192.57.78.159
9-
When installing the IGRP routing protocol which of the following is also required?
A -
Metric weights.
B -
Autonomous system number.
C -
IP address mask.
D -
Connected network numbers.
10-
Cisco has just released a new version of Cisco IOS and you would like to use this new version. You have
downloaded this IOS from Ciscos web site and stored it on your TFTP server. Which of the following
commands should you use to copy this IOS to your router?