You are unable to connect to the companys local tftp server using the IP address 10.0.0.20 from your
personal computer. You would to test your personal computer to make sure the TCP/IP has been
corrected installed. Which one of the following actions will allow you to test the protocol stack on your
personal computer?
A -
Ping 127.0.0.0
B -
Ping 203.125.12.1
C -
Telnet 127.0.0.1
D -
Ping 127.0.0.1
2-
Users on your network 10.1.0.0/16 are complaining that they cannot access the companys intranet server
using the FQDN www.snowball.com. You are able to ping the IP address but you cannot ping
www.snowball.com.
What is the likely cause of this problem?
A -
TCP/IP failure.
B -
DNS failure.
C -
FTP failure.
D -
SNMP failure.
3-
Given the network 192.141.27.0/28, identify the valid host addresses.
A -
192.141.27.33
B -
192.141.27.119
C -
192.141.27.126
D -
All of the above
4-
To perform proper and efficient routing what must a router have?
A -
Destination application of an incoming packet.
B -
Number of other packets in a single flow of data.
C -
Destination network address of an incoming packet.
D -
Number of routers that know a path to the destination.
5-
Exhibit: I 154.128.16.0 [100/1100] via 30.100.192.4, 00:00: Ethernet 0
Your trainee studies the routing table on your Catalyst 5000 Switch. One specific entry draws the
attention of the trainee (see Exhibit). He is curious about the number 1100 and asks you how it is
calculated. You need to tell the trainee what is used in the calculation.
A -
administrative distance
B -
hop count
C -
delay
D -
metric
6-
To configure a console password you type the following command what would normally follow this
command? routers(config) #line console 0
Which operation is most likely to follow?
A -
Configure terminal type.
B -
Enter protocol parameters for a serial line.
C -
Create a password on the console terminal line.
D -
Establish a terminal type 4 connection to a remote host.
7-
For what purpose does Frame Relay use DLCIs?
A -
They determine the Frame Relay encapsulation type.
B -
They identify the logical circuit between a local router and a Frame Relay WAN switch.
C -
The represent the keepalives used to maintain the PVC in an active state.
D -
They represent the physical address of the router attached to a Frame Relay network.
8-
Based on the output of the show ip route command which route will not be entered into a neighbor RIP
router?
A -
R 192.168.3.0/24 [120/1] via 192.168.2.2, 00:00:10, Serial0
B -
R 192.168.11.0/24 [120/7] via 192.168.9.1, 00:00:03, Serial1
C -
R 192.168.5.0/24 [120/15] via 192.168.2.2, 00:00:10, Serial0
D -
C 192.168.1.0/24 is directly connected, Ethernet0
9-
Which one of the following commands will allow you to configure a login password that will be used
when you connect to the routers console port using the roll-over from your notebook?
A -
Line console Login Password Cisco
B -
Line login terminal Password Cisco
C -
Line console 0 Login Password CISCO
D -
Line console 0 Login Password Cisco
10-
Which WAN technology uses two Bearer (B) channels for data plus one Delta (D) channel for signaling
information?