You have just created an IP extended access list and now wish to apply this to an interface. Which
command will allow you to apply the list to an interface?
A -
Permit access-list 101 out
B -
Ip access-group 101 out
C -
Apply access-list 101 out
D -
Access-class 101 out
2-
Which one of the following characteristics about Ethernet Switches is true?
A -
Symmetric switching allows connection between ports of unlike bandwidth and does not require memory buffering.
B -
Memory buffering is used to prevent a bottleneck when ports of different bandwidth are connected on a symmetric switch.
C -
The cut-trough method of switching is faster because the switch forwards the packet to the destination as soon as it reads the destination address.
D -
The latency can be reduced if the switch utilizes the store and forward method of switching. Store and forward is better for error detection.
3-
To configure RouterTK for operation in a Frame Relay environment, one of the recommended items to
configure is the IGRP metric for the speed of the link. What command should you use?
A -
RouterTK(config)# IGRP metric 36k
B -
RouterTK(config)# bandwidth 36
C -
RouterTK(config-if)# metric 36k
D -
RouterTK(config-if)# bandwidth 36
4-
Exhibit
You have created an Extended IP access list. Now you apply the access list to Ethernet 0.
What is the result of this action?
A -
All TCP protocols will be permitted out of Ethernet 0 except e-mail and telnet.
B -
All IP traffic out of Ethernet 0 will be denied.
C -
All hosts on the 172.30.24.64 network will be permitted e-mail and telnet access.
D -
Only e-mail and telnet access will be permitted out of Ethernet 0.
5-
Which of the following ranges are used for IPX standard access lists?
A -
100 - 199
B -
600 - 699
C -
800 - 899
D -
1000 - 1099
6-
There are three major groups of routing protocols: distance-vector protocols, link-state protocols, and
hybrid protocols. Select two valid statements regarding routing protocols?
A -
Distance vector protocols send updates about directory connected neighbors to all networks listed in the routing table.
B -
Distance vector protocols send the entire routing table to directly connected neighbors.
C -
Link state protocols send updates containing the state of their own links to all other routers on the network.
D -
Both B & C
7-
Consider a standard half- duplex Ethernet circuitry. What is true concerning this circuitry?
A -
It is alternate one-way communication.
B -
The receive (RX) is wired directly to the transmit (TX) of the remote station.
C -
The receive (TX) is wired directly to the receive (RX) of the remote station.
D -
Collisions are not possible.
8-
You are configuring R3 so that it can communicate with R2 on Ethernet port e1. What encapsulation
should you use on s0 to setup this IPX network?
A -
SAP
B -
HDLC
C -
ARPA
D -
Novell-Ether
9-
You just purchased a brand new Cisco 2621 Router and now would like to configure password protection
on this router. Which of the following are true regarding passwords on this router?
A -
All passwords can be encrypted.
B -
A password can be set before a user can enter the privileged mode.
C -
A password can be set for individual lines.
D -
All of the above
10-
You want to make sure that access-list you just created does not conflict with an existing access-list.
Which router command allows you to view all of the access-lists created and the contents of all access
lists?