Your company has decided to use a (BRI) connection between the Florida office and the Georgia office.
You would like to configure dial on demand routing (DDR) on this connection. Which of the following
commands are required to setup DDR?
A -
Define static routes.
B -
Specify interesting traffic that can enable the link.
C -
Configure the dialer information.
D -
All of the above
2-
For security reasons you would like a system message displayed when logging into a router. Which of the
following allows you to create this message?
A -
Banner MOTD
B -
Message MOTD
C -
Banner Message
D -
Message Banner
3-
You have just configured DDR (Dial on Demand Routing) and would like to test the link. What can you
use to bring up the connection?
A -
Increase the idle timeout parameter.
B -
Send interesting traffic across the link.
C -
Reboot one of the Integrated Services Digital Network (ISDN) routers.
D -
Reset the DDR Integrated Services Digital Network (ISDN) router statistics to zero.
4-
You need to create a subinterface so that you can support different Frame-Relay encapsulations. Which
command specifies a second subinterface on serial interface zero?
A -
Interface s 0.2 point - to point.
B -
Interface 2 s 0 point to point.
C -
Sub interface 2 s 0 point to point.
D -
Interface 0 sub 2 point to point.
5-
You issued the show spantree e0/1 command which part of the output indicates that virtual LAN1
(VLAN1) is functioning properly?
A -
Port Ethernet 0/1 of VLAN is forwarding.
B -
Designated port is Ethernet 0/1, path cost 10.
C -
Designated root has priority 0 address 00D0.588F.B600.
D -
VLAN is executing the IEEE compatible spanning tree protocol.
6-
Frame Relay uses ___________ to define the rate, in bits per second , that the Frame Relay switch agrees
to transfer data?
A -
Clock rate (CR).
B -
Committed Information Rate (CIR)
C -
Local management interface (LMI)
D -
Data-link connection identifier (DLCI)
7-
You are trying to determine if the connection between your Router and the Frame-Relay switch is good.
Which show command should you use to view Frame Relay local management interface (LMI) traffic
statistics?
A -
Show ip route.
B -
Show interface.
C -
Show statistics.
D -
Show frame-relay lmi.
8-
Which of the following is a Layer 2 device?
A -
Hub
B -
Router
C -
Switch
D -
Repeater
9-
You are configuring the IPX encapsulation between RouterA and RouterB. This connection will be using
the S0/0 port on RouterA to S0/0 on RouterB. Which encapsulation type should be used for the S0/0 port
of RouterB?
A -
SAP
B -
HDLC
C -
ARP
D -
NOVELLETHER
10-
Our network uses both IPX and IP addressing and we have a direct connection to the Internet using IP.
We would like to allow our IPX traffic to also be able to go across this internet to a remote router on the
other side. Which term below will allow us to encapsulation IPX inside of IP so that we can send it across
the Internet?