What output interface status would you see if peer interface (on second end of link) is administratively
down?
A -
Interface is down, line protocol is down.
B -
Interface is down, line protocol is up.
C -
Interface is up, line protocol is down.
D -
Interface is up, line protocol is up.
2-
What is the protocol and what is the second part of the following network address? (Choose all that
apply.)
172.161.0.254 mask 255.255.0.0
A -
IPX MAX address.
B -
IP Class C director broadcast.
C -
Private IP address node number.
D -
Public IP address directed broadcast.
3-
What IP address class is multicast?
A -
A
B -
B
C -
C
D -
D
4-
Which of the following metrics does IGRP use by default to determine the best path to destination?
A -
Maximum Transmission Unit.
B -
Cumalative Interface delay.
C -
Path bandwidth value.
D -
Both B & C
5-
What must you do to test connectivity on a dial on demand routing (DDR) link?
A -
Increate the idle import parameter.
B -
Send interesting traffic across the link.
C -
Switch
D -
Repeater
6-
You got a new testing application on a new server in your office. This testing application work with a few
hosts. The new server and hosts work with 10 Mbps and make a bandwidth problem for all the rest non-
testing hosts. The rest of the hosts in your office network with 2 Mbps.
What is the most economical decision would you implement for resolving this problem?
A -
Install new 100 Mbps switches, and change all host's NIC to 100 Mbps.
B -
Segment network with router, and place all testing hosts and the new server into a separate subnet (network).
C -
Add a Bridge and separate the two networks.
D -
All of the above
7-
A user issues the command ping 204.211.38.52.
Which of the following physical is used to test physical connectivity between the two devices?
A -
ICMP echo request.
B -
Information request.
C -
Timestamp reply.
D -
Redirect.
8-
How do you change the Console password to "cisco"?
A -
Router(config)# line con 0 Router(config-line)# login Router(config-line)# password cisco
B -
Router(config)# line con 0 Router(config-line)# login Router(config-line)# password Cisco
C -
Router(config)# line con 0 Router(config-line)# login Router(config-line)# Password cisco
D -
Router(config)# line con 0 Router(config-line)# login Router(config-line)# Password Cisco
9-
Cisco IOS allows which keystroke(s) to complete the syntax of a partially entered command?
A -
Ctrl+shift+6 then x.
B -
Ctrl+Z
C -
TAB
D -
/?
10-
Given an IPX network with redundant paths, what command will configure load balancing?