Which command can be used from a PC to verify the connectivity between hosts that connect
through a switch in the same LAN?
A -
ping address
B -
tracert address
C -
traceroute address
D -
arp address
3-
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?
A -
defines the destination IP address that is used in all broadcast packets on DCLI 202
B -
defines the source IP address that is used in all broadcast packets on DCLI 202
C -
defines the DLCI on which packets from the 192.168.1.2 IP address are received
D -
defines the DLCI that is used for all packets that are sent to the 192.168.1.2 IP address
4-
Which command would you configure globally on a Cisco router that would allow you to view
directly connected Cisco devices?
A -
enable cdp
B -
cdp enable
C -
cdp run
D -
run cdp
5-
efer to the exhibit. When running OSPF, What would cause router A not to form an adjacency
with router B?
A -
The values of the dead timers on the routers are different.
B -
The loopback addresses are on different subnets.
C -
Route summarization is enabled on both routers.
D -
The process identifier on router A is different than the process identifier on router B.
6-
What is some of the advantages of using a router to segment the network?
A -
Broadcasts are eliminated.
B -
Routers generally cost less than switches.
C -
Broadcasts are not forwarded across the router.
D -
Adding a router to the network decreases latency.
7-
What is an appropriate use of a default route?
A -
to provide routing to a destination that is not specified in the routing table and which is outside the local network
B -
to provide routing that will override the configured dynamic routing protocol
C -
to provide routing from an ISP to a stub network
D -
to provide routing to a local web server
8-
A network administrator is verifying the configuration of a newly installed host by establishing an
FTP connection to a remote server. What is the highest layer of the protocol stack that the network
administrator is using for this operation?
A -
transport
B -
session
C -
application
D -
presentation
9-
You have finished physically installing an access point on the ceiling at your office. At a minimum,
which parameter must be configured on the access point in order to allow a wireless client to
operate on it?
A -
SSID
B -
PSK
C -
AES
D -
tkip
10-
Refer to the exhibit. What can be determined about the router from the console output?
A -
Configuration file is normal and will load in 15 seconds.
B -
No configuration file was found in NVRAM.
C -
No configuration file was found in flash.
D -
No configuration file was found in the PCMCIA card.