When setting up Frame Relay for point-to-point subinterfaces, you enter the following configuration:
Which of the following must not be configured?
A -
The Frame Relay encapsulation on the physical interface.
B -
The local DLCI on each subinterface.
C -
An IP address on the physical interface.
D -
The subinterface type as point-to-point.
2-
What is an advantage of segmenting your LAN with a switch?
A -
Smaller collision domains.
B -
Elimination of broadcast.
C -
Decrease cost of implementation.
D -
Larger number of users within the same domain.
3-
Your ISP has provided you the following class B network range 131.107.0.0/24. Which of the following
statements is true regarding this network?
A -
There are 254 usable hosts per subnet.
B -
There are 254 usable subnets.
C -
There are 255 usable hosts per subnet.
D -
Both A & B
4-
You just purchased a Cisco router from an online auction and now you have configured the router and
everything is working perfectly in your test lab. You then issue the command copy run start to save your
configuration to NVRAM. You turn off the power and mount the router in the production rack. After
connecting the power cord you power up the router and the router boots into setup mode. You issue the
show startup-config from privileged mode and your entire configuration is there. Which of the following
indicates a possible source of the problem?
A -
Hardware failure NVRAM prevents the router from loading the configuration.
B -
Startup-config in flash is corrupt and cannot be analyzed.
C -
Router configuration register set to bypass startup configuration.
D -
Startup-config in NVRAM is corrupt and cannot be analyzed.
5-
Once you have defined interesting traffic with the dialer-list command, you then must associate an ISDN
phone number with the next hop router address. Which IOS command should you use?
A -
Isdn destination number.
B -
Dialer map.
C -
Isdn spid1.
D -
Isdn line number.
6-
You have just purchased a new Cisco router. Which mode should you use to create an initial
configuration on your router?
A -
Copy mode.
B -
User mode.
C -
Setup mode.
D -
Startup mode.
7-
If RIP uses hop count to determine the best path what does IGRP use?
A -
The highest metric value.
B -
The lowest composite metric value.
C -
The lowest hop-count and delay.
D -
The highest bandwidth and reliability
8-
Exhibit
You are network administrator for the network shown in the exhibit above. Adding the new router,
called TK2, the network has been augmented. You would like to backup the IOS image of the new router
to the TFTP server. However, the backup procedure fails.
What could be the cause of the problem?
A -
Incorrect default gateway of the tftp server.
B -
Incorrect subnet mask of the tftp server.
C -
Incorrect IP address of the tftp server.
D -
Incorrect IP address on E0 of the TK1 server.
9-
Your company is using ISDN to connect the Remote office to the Central office. The connection is not
working between the two routers. You issue the show running-config command looking at the
configuration above. Which additional command must be issued on the Central router before interesting
traffic will be sent to the Remote router?
A -
(config-if)# dialer-group 1
B -
(config-if)# dialer-list 1
C -
(config-if)# dialer map 1
D -
(config-if)# dialer-route 1
10-
What one of the following protocols is an example of a link state routing protocol that uses the TCP/IP
protocol stack?