Refer to the exhibit. Which destination addresses will Host A use to send data to Host B?
A -
the IP address of Switch1
B -
the IP address of Router1 Fa0/0
C -
the IP address of HostB
D -
the MAC address of Switch1
2-
The network security policy requires that only one host be permitted to attach dynamically to each
switch interface. If that policy is violated, the interface should shut down. Which one commands
must the network administrator configure on the 2950 Catalyst switch to meet this policy?
Refer to the graphic. A static route to the 10.5.6.0/24 network is to be configured on the HFD
router. Which commands will accomplish this?
A -
HFD(config)# ip route 10.5.6.0 0.0.0.255 fa0/0
B -
HFD(config)# ip route 10.5.6.0 0.0.0.255 10.5.4.6
C -
HFD(config)# ip route 10.5.6.0 255.255.255.0 fa0/0
D -
HFD(config)# ip route 10.5.4.6 0.0.0.255 10.5.6.0
4-
What should be done prior to backing up an IOS image to a TFTP server?
A -
Make sure that the server can be reached across the network.
B -
Assure that the network server has adequate space for the IOS image.
C -
Verify file naming and path requirements.
D -
All of the above
5-
Which is valid modes for a switch port used as a VLAN trunk?
A -
auto
B -
on
C -
desirable
D -
All are correct
6-
The network 172.25.0.0 has been divided into eight equal subnets. Which of the following IP
addresses can be assigned to hosts in the third subnet if the ip subnet-zero command is
configured on the router?
A -
172.25.78.243
B -
172.25.94.255
C -
172.25.72.0
D -
All of the above
7-
Refer to the graphic. Host 1 cannot receive packets from Host 2. Assuming that RIP v1 is the
routing protocol in use, what is wrong with the IP configuration information shown?
A -
The fa0/1 interface of router R2 has been assigned a broadcast address.
B -
Host 2 has been assigned the incorrect subnet mask.
C -
Host 1 has been configured with the 255.255.248.0 subnet mask.
D -
Host 2 on router R2 is on a different subnet than its gateway.
8-
What is one valid reasons to assign ports to VLANs on a switch?
A -
to isolate broadcast traffic
B -
to logically group hosts according to function
C -
to increase network security
D -
All of the above
9-
Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links
are operating at the same bandwidth?
A -
Switch A - Fa0/1
B -
Switch B - Fa0/0
C -
Switch B - Fa0/1
D -
All of the above
10-
Which statements describe one of the benefits of VLAN Trunking Protocol?
A -
VTP allows phVTP allows routing between VLANs. ysically redundant links while preventing switching loops.
B -
VTP allows routing between VLANs.
C -
VTP simplifies switch administration by allowing switches to automatically share VLAN configuration information.
D -
VTP allows a single switch port to carry information to more than one VLAN.