In addition to assigning an IP address, Which of the following correctly describe regarding TCP/IP
stack configuration features can DHCP provide?
A -
Default gateway
B -
DNS servers
C -
Subnet mask
D -
All of them
2-
As the network administrator, you have been instructed to prevent all traffic originating on the
Router 1 LAN from entering the router2. Which the following command would implement the
access list on the interface of router2?
A -
ip access-group 101 in
B -
access-list 101 in
C -
ip access-group 101 out
D -
access-list 101 out
3-
The command frame-relay map ip 10.121.16.8 102 broadcast was entered on the router. Which of
the following statements is true concerning this command?
A -
The broadcast option allows packets, such as RIP updates, to be forwarded across the PVC.
B -
This command is required for all Frame Relay configurations.
C -
102 is the remote DLCI that will receive the information.
D -
The IP address 10.121.16. 8 is the local router port used to forward data.
4-
To which port of Sw-AC3 is router VLAN-R1 connected?
A -
Sw-DS1
B -
Sw-AC1
C -
Sw-AC2
D -
Sw-AC3
5-
You just entered the following command:
Company (config)# line console 0
A -
Configure the terminal type.
B -
Enter protocol parameters for a serial line.
C -
Create a password on the console terminal line.
D -
Establish a terminal type 4 connection to a remote host.
6-
The Company WAN is migrating from RIPv1 to RIPv2. Which three statements are correct about
RIP version 2?
A -
It has the same maximum hop count as version 1.
B -
It is a classless routing protocol.
C -
It supports authentication.
D -
All of the above.
7-
Three access points have been installed and configured to cover a small office. What term defines
the wireless topology?
A -
BSS
B -
IBSS
C -
ESS
D -
SSID
8-
The Frame Relay network in the diagram is not functioning properly. What is the cause of the
problem?
A -
The Gallant router has the wrong LMI type configured.
B -
The IP address on the serial interface of the Attalla router is configured incorrectly.
C -
The frame-relay map statement in the Attalla router for the PVC to Steele is not correct.
D -
The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf command.
9-
Refer to the exhibit. The switches on a campus network have been interconnected as shown. All
of the switches are running Spanning Tree Protocol with its default settings. Unusual traffic
patterns are observed and it is discovered that Switch9 is the root bridge. Which change will
ensure that Switch1 will be selected as the root bridge instead of Switch9?
A -
Raise the bridge priority on Switch9.
B -
Physically replace Switch9 with Switch1 in the topology.
C -
Disable spanning tree on Switch9.
D -
Lower the bridge priority on Switch1.
10-
What is one recommended ways of protecting network device configuration files from outside
network security threats?
A -
Allow unrestricted access to the console or VTY ports.
B -
Always use Telnet to access the device command line because its data is automatically encrypted.
C -
Use SSH or another encrypted and authenticated transport to access device configurations.
D -
Prevent the loss of passwords by disabling password encryption.