The network administrator requires easy configuration options and minimal routing protocol traffic.
What one options provide adequate routing table information for traffic that passes between the
one routers and satisfy the requests of the network administrator?
A -
a dynamic routing protocol on CentralRouter to advertise summarized routes to CentralRouter.
B -
a dynamic routing protocol on InternetRouter to advertise summarized routes to CentralRouter.
C -
a static default route on CentralRouter that directs traffic to InternetRouter.
D -
a dynamic, routing protocol on CentralRouter to advertise all routes to CentralRouter.
2-
What is the effect of using the service password-encryption command?
A -
Only the enable password will be encrypted.
B -
It will encrypt all current and future passwords.
C -
It will encrypt the secret password and remove the enable secret password from the configuration.
D -
Only the enable secret password will be encrypted.
3-
Refer to the exhibit.
The network administrator cannot connect to Switch1 over a Telnet session, although the hosts
attached to Switch1 can ping the interface Fa0/0 of the router. Given the information in the graphic
and assuming that the router and Switch2 are configured properly, which of the following
commands should be issued on Switch1 to correct this problem?
A -
Switch1(config)# interface fa0/1 Switch1(config-if)# ip address 192.168.24.3.255.255.255.0
Switch1(config)# interface fa0/1 Switch1(config-if)# duplex full Switch1(config-if)# speed 100
D -
Switch1(config)# ip default-gateway 192.168.24.1
4-
Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and
has built-in security mechanisms?
A -
Frame Relay
B -
X.25
C -
PPP
D -
HDLC
5-
Which statement about access lists that are applied to an interface is true?
A -
You can configure one access list, per direction, pet Layer 3 protocol
B -
You can apply multiple access lists with the same protocol or in different director
C -
You can apply only one access list on any interface
D -
You can plane as many access lists as you want on any interface
6-
Which parameter CM parameters are used to calculate OSPF cost in Cisco routers?
A -
Bandwidth. Delay, and MTU
B -
Bandwidth. MTU. Reliability. Delay, and Load
C -
Bandwidth
D -
Bandwidth and Delay
7-
Refer to the exhibit.
Four Cisco 2950 switches are set to their default priority settings. During the spanning-tree
process, which switch will be elected as the root bridge?
A -
Switch4
B -
Switch2
C -
Switch1
D -
Switch3
8-
A network administrator needs to configure a serial link between the main office and a remote
location. The router at the remote office is a non-Cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?
A -
Main(config)# interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#encapsulation ietf Main(config-if)# no shut
B -
Main(config)# interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)# no shut
C -
Main(config)# interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#encapsulation PPP Main(config-if)# no shut
D -
Main(config)# interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#encapsulation frame-relay Main(config-if)# authentication chap Main(config-if)# no shut
9-
Refer to the exhibit.
A network administrator attempts to ping Host2 from Host1 and receives the results that are
shown. What is a possible problem?