Which command can be used from a PC to verfy the connectivity between host that connect
through path?
A -
tracert address
B -
ping address
C -
arp address
D -
traceroute address
2-
In which solution is a router ACL used?
A -
protecting a server from unauthorized access
B -
controlling path selection,based on the route metric
C -
reducing router CPU utilization
D -
filtering packets that are passing through a router
3-
A router has two Fast Ethernet interfaces and needs to connect to four VLANs in the local
network. How can you accomplish this task, using the fewest physical interfaces and without
decreasing network performance?
A -
Add two more FastEthernet interfaces.
B -
Add a second router to handle the vlan traffic.
C -
Use a hub to connect the four vlans with a FastEthernet interface on router.
D -
Implement a router-on-a-stick configuration.
4-
Refer to the exhibit.
How many broadcast domains are configured on switch2?
A -
50
B -
4
C -
1
D -
0
5-
Refer to the exhibit.
The speed of all serial links is E1 and the speed of the all Ethernet links is 100Mb/s. A static route
will be established on the Manchester router to the direct traffic toward the internet over the most
direct path available. What configuration on the Manchester router will establish a router toward
the internet for traffic that originates from workstation on the Manchester LAN?
A -
ip route 0.0.0.0 255.255.255.255 172.16.100.2
B -
ip route 0.0.0.0 0.0.0.0 172.16.100.1
C -
ip route 0.0.0.0 0.0.0.0 172.16.100.2
D -
ip route 0.0.0.0 0.0.0.0 128.107.1.1
6-
What Frame Relay mechanism is used to build the map illustrated in the accompanying graphic?
A -
inverse multiplexing
B -
LMI maping
C -
Inverse ARP
D -
ARP
7-
Refer to the exhibit. A network engineer is troubleshooting an internet connectivity problem on the
computer. What is causing the problem?
A -
wrong DNS server
B -
wrong default gateway
C -
incorrect IP address
D -
incorrect subnet mask
8-
How many broadcast domains are shown in the graphic assuming only the default vlan is
configured on the switches?
A -
one
B -
six
C -
twelve
D -
two
9-
How dose a DHCP server dynamically assign IP address to host?
A -
Addresses are allocated after a negotiation between the server and the host to determine the length of the agreement.
B -
Addresses are assigned for a fixed period of time.At the end of period,a newquest for an address must be made ,and another address is then assigned.
C -
Addresses are leased to host.A host will usually keep the same address by periodically contacting the DHCP sever to renew the lease.
D -
Addresses are permanently assigned so that the host uses the same address at all times.
10-
What is the default maximum number of equal-cost paths that can be placed into the routing table
of a Cisco OSPF router?