When you configure an IP address on a Cisco Router, which command starts the IP processing on the
interface?
A -
IP-Space enable.
B -
Network IP-Address.
C -
IP address IP-address subnet mask.
D -
The exit command from the enable configuration.
2-
When you issue the command show version, your router returns:
"Configuration register is 0x0101"
From where does the router boot?
A -
ROM
B -
NVRAM
C -
FLASH
D -
A TFTP server
3-
Which line from a show spantree one-command output indicates that Virtual LAN1 (VLAN1) is
functioning properly?
A -
Port Ethernet 0/1 of VLAN is forwarding.
B -
Designated port in Ethernet 0/1 path cos10.
C -
Designated root has priority 0, address 0000.588fb600
D -
VLAN1 is executing the IEEE compatible spanning tree protocol.
4-
Which statement about the data-link connection identifier (DLCI) is true?
A -
It is a number that identifies a local virtual circuit in Frame Relay network.
B -
It is a signaling standard between the CPE device and the Frame Relay switch.
C -
It is check speed port speed of the connection (local loop) to the Frame Relay cloud.
D -
It is maximum number of uncommitted bits that the Frame Relay switch will attempt to transfer beyond the committed information rate (CIR).
5-
What is the most common mail to device?
A -
Hub
B -
Router
C -
Repeater
D -
Switch
6-
While you are preparing the initial configuration of your router and enable IP you find that you need to
use a telnet session to check for a network address parameter. Your telnet logging and your virtual
transmission session on the other device are successful. What is the default that you must enter to
suspend your Telnet session and return to the original router?
A -
CTRL – ESC followed by x.
B -
CTRL- Shift-6 followed by x.
C -
CTRL – ALT – DEL followed b ESC.
D -
The command exit.
7-
Which ex command displays system configuration information, software version and the names and
sources of configuration files and boot images on a router?
A -
Show Config.
B -
Show flash.
C -
Show version.
D -
Show boot.
8-
The exhibit shows the Cisco routers startup messages.
Which group of messages identifies the router components that you can configure during set up the initial
system configuration?
A -
System Bootstrap, Version 11.3(1)XA, PLATFORM SPECIFIC RELEASE SOFTWARE (fc1) Copyright (c) 1998 by cisco Systems, Inc, CS2600 platform with 32768 Kbytes of main memory
B -
Rp,,pm 1 b f program load complete, entry point: 0x800008000, size: 0xef4e0 Self decompressing the image :############################[OK]
C -
Notice: NVRAM invalid, possible due to write erase, program load complete, entry point:0x80008000, size 0x415b20 Self decompressing the image: ################################### ##########################################################[OK
D -
Cisco Internetwork Operating System Software IOC (tm) C2600 Software (C2600-JS-M), Version 11.3(2)XA, PLATFORM SPECIFIC RELEASE SOFTWARE (fc1) Copyright 1996-1998 by Cisco Systems Inc. Compiled 10-Mar-98 14:25 by gneale Image text-bas: 0x80008084, database: 0x809CD49C
9-
Which encapsulation type should be used for the S0 port of router R2?
A -
SAP
B -
HDLC
C -
ARPA
D -
Novel Ether
10-
Which encapsulation type should be used for the e1 port of Router R3?