Your company has decided to use IGRP instead of RIP as the routing protocol. They want to use
autonomous system number 130. Which is the correct command for this installation?
A -
Router(config)# igrp 130
B -
Router(config)# network 130
C -
Router(config)# router igrp 130
D -
Router(config)# enable igrp 130
2-
TestKing1 cannot establish a connection to TestKing2 using the show interface serial 0/0 command on
TestKing1 command which layer of the OSI model is most likely the problem?
A -
Physical layer.
B -
Data layer.
C -
Network layer.
D -
Transport layer.
3-
All TCP/IP hosts implement the ICMP protocol?
A -
TRUE
B -
FALSE
4-
Aaron is troubleshooting a problem on his network he issues the command ping 10.0.0.2 to test the
physical connectivity between two devices? Which type of ICMP messages was carried in the IP
datagrams?
A -
Information request.
B -
ICMP echo request.
C -
Timestamp reply.
D -
Redirect.
5-
Looking at the diagram above ports 1 through 4 are assigned to VLAN1 and ports 5 through 8 are
assigned to VLAN3 on each switch. The switches are interconnected over an ISL trunk link.
Which of the following actions would test proper VLAN and trunk operation?
A -
Host 2-1 can ping Host 2-2
B -
Host 2-1 can not ping Host 2-2
C -
Host 7-1 can ping Host 7-2
D -
All of the above
6-
Christopher issues a show cdp neighbor command from RouterA. RouterA has connections to RouterB
and RouterC through the serial s0 and s1. Which three pieces of CDP information about neighboring
routers are displayed on your console terminal?
A -
The neighboring routers host name.
B -
The neighboring routers hardware platform.
C -
Up to one address for each protocol supported.
D -
All of the above
7-
How do you change the Console password on the Sonic router to "cisco"?
A -
Sonic(config)#line con 0 Sonic(config-line)#login Sonic(config-line)#password cisco
B -
Sonic(config)#line con 0 Sonic(config-line)#login Sonic(config-line)# password Cisco
8-
You have just entered the command:
Superhero(config-line)#logging sync
Cisco IOS allows which keystroke(s) to complete the syntax of a partially entered command.
Which keystroke(s) did you use to complete the above command above to the completed command
below?
Superhero(config-line)#logging synchronous
A -
Ctrl+shift+6 then x.
B -
Ctrl+Z
C -
TAB
D -
/?
9-
Which of the following statements about layer 2 bridges and switches are true?
A -
Both bridges and switches forward Layer 2 broadcasts.
B -
Switches have a higher number of ports than most bridges.
C -
Both bridges and switches make forwarding decisions based on Layer 2 addresses.
D -
All of the above
10-
Julia telnets to a pc on a remote subnet, which MAC address will be present in the ARP table when you
issue the show arp command?
A -
MAC address of the destination host Ethernet port.
B -
MAC address of the local router Ethernet port.
C -
MAC address of the destination router Serial port.