Refer to the exhibit. Which WAN protocol is being used?
A -
ATM
B -
HDLC
C -
Frame Relay
D -
ppp
3-
What is the difference between a CSU/DSU and a modem?
A -
A CSU/DSU converts analog signals from a router to a leased line; a modem converts analog signals from a router to a leased line.
B -
A CSU/DSU converts analog signals from a router to a phone line; a modem converts digital signals from a router to a leased line.
C -
A CSU/DSU converts digital signals from a router to a phone line; a modem converts analog signals from a router to a phone line.
D -
A CSU/DSU converts digital signals from a router to a leased line; a modem converts digital signals from a router to a phone line.
4-
A network administrator must configure 200 switch ports to accept traffic from only the currently
attached host devices. What would be the most efficient way to configure MAC-level security on all
these ports?
A -
Visually verify the MAC addresses and then telnet to the switches to enter the switchport-port security mac-address command.
B -
Have end users e-mail their MAC addresses. Telnet to the switch to enter the switchport-port security mac-address command.
C -
Use the switchport port-security MAC address sticky command on all the switch ports that have end devices connected to them.
D -
Use show mac-address-table to determine the addresses that are associated with each port and then enter the commands on each switch for MAC address port-security.
5-
When troubleshooting a Frame Relay connection, what is the first step when performing a
loopback test?
A -
Set the encapsulation of the interface to HDLC.
B -
Place the CSU/DSU in local-loop mode.
C -
Enable local-loop mode on the DCE Frame Relay router.
D -
Verify that the encapsulation is set to Frame Relay.
6-
What occurs on a Frame Relay network when the CIR is exceeded?
A -
All TCP traffic is marked discard eligible.
B -
All UDP traffic is marked discard eligible and a BECN is sent.
C -
All TCP traffic is marked discard eligible and a BECN is sent.
D -
All traffic exceeding the CIR is marked discard eligible.
7-
What is one characteristics of Frame Relay point-to-point subinterfaces?
A -
They create split-horizon issues.
B -
They require a unique subnet within a routing domain.
C -
They are ideal for full-mesh topologies.
D -
They require the use of NBMA options when using OSPF.
8-
Refer to the exhibit. Addresses within the range 10.10.10.0/24 are not being translated to the 1.1.128.0/16 range. Which command shows if 10.10.10.0/24 are allowed inside addresses?
A -
debug ip nat
B -
show ip nat translation
C -
show ip nat statistics
D -
show access-list
9-
A wireless client cannot connect to an 802.11b/g BSS with a b/g wireless card. The client section
of the access point does not list any active WLAN clients. What is a possible reason for this?
A -
The incorrect channel is configured on the client.
B -
The client's IP address is on the wrong subnet.
C -
The client has an incorrect pre-shared key.
D -
The SSID is configured incorrectly on the client.
10-
Which one features did WPAv1 add to address the inherent weaknesses found in WEP?