access-list 2500 deny tcp any host 192.168.1.1 eq 22
D -
access-list 101 deny tcp any host 192.168.1.1
3-
What is one benefit of PVST+?
A -
PVST+ reduces the CPU cycles for all the switches in the network
B -
PVST+ automatically selects the root bridge location, to provide optimiz
C -
PVST+ allows the root switch location to be optimized per VLAN.
D -
PVST+ supports Layer 3 load balancing without loops.
4-
What would be the effect of issuing the command ip access-group 114to lo the fa0/0 interface?
A -
Attempts to telnet to the router would fail.
B -
It would allow all traffic from the 10.4.4.0 network.
C -
IP traffic would be passed through the Interface but TCP and UDP traffic would not.
D -
Routing protocol updates for the 10.4.4.0 network would not be accepted from the fa0/0 interface
5-
What would be the effect of issuing the command ip access-group 115 in on the s0/0/1 interface?
A -
No host could connect to RouterC through s0/0/1.
B -
Telnet and ping would work but routing updates would fail.
C -
FTP, FTP-DATA, echo, and www would work but telnet would fail.
D -
Only traffic from the 10.4.4.0 network would pass through the interface.
6-
Which statement is true?
A -
An IPv6 address is 64 b long and is represented as hexadecimal characters.
B -
An IPv6 address is 32 b long and is represented as decimal digits.
C -
An IPv6 address is 128 b long and is represented as decimal digits.
D -
An IPv6 address is 128 b long and is represented as hexadecimal characters.
7-
In which circumstance are multiple copies of the same unicast frame likely to be transmitted in a
switched LAN?
A -
after broken links are re-established
B -
in an improperly implemented redundant topology
C -
when upper-layer protocols require high reliability
D -
during high traffic periods
8-
Which command sets and automatically encrypts the privileged enable mode password?
A -
password enable c1sc0
B -
enable secret c1sc0
C -
secret enable c1sc0
D -
enbale password c1sc0
9-
A router receives information about network 192.168.10.0/24 from multiple sources. What will the
router consider the most reliable information about the path to that network?
A -
a static router to network 192.168.10.0/24
B -
a static router to network 192.168.10.0/24 with a local serial interface configured as the next hop
C -
a RIP update for network 192.168.10.0/24
D -
a directly connected interface with an address of 192.168.10.254/24
10-
Which one commands can be used to verify a trunk link configuration status on a given Cisco
switch?