Enter the command to start IP, RIP version1 routing on a Cisco router?
A -
Router rip
B -
RIP include
C -
Route network
D -
Network Devices
2-
Which two statements about the store and forward switching method are true?
A -
Latency remains constant regardless of frame size.
B -
Latency through the switch varies with frame length.
C -
The switch receives the complete frame before beginning to forward it.
D -
Both B & C
3-
You are configuring a new catalyst switch that you want to manage remotely from workstations on other
network segment within your enterprise.
Which of the following are required to allow remote management of the switch over IP?
A -
The Frame Relay encapsulation on the physical interface.
B -
The local DLCI on each subinterface.
C -
An IP address on the physical interface.
D -
The subinterface type as point-to-point.
4-
Which sequence of actions will allow telnetting from a user's PC to a router using TCP/IP?
A -
Connect the PC's COM port to the router's console port using a straight-through cable.
B -
Connect the PC's COM port to the router's console port using a crossover cable.
C -
Connect the PC's COM port to the router's Ethernet port using a straight-through cable.
D -
Connect the PC's Ethernet port to the router's Ethernet port using a crossover cable.
5-
Full Duplex Ethernet can operate between which of the following devices?
A -
Switch to host.
B -
Switch to switch.
C -
Hub to hub.
D -
Both A & B
6-
What is the bit pattern for the first octet of a class A network address?
A -
0xxxxxxx
B -
10xxxxxx
C -
110xxxxx
D -
1110xxxx
7-
What is the network address for a host with the IP address 201.100.5.68/28?
A -
201.100.5.0
B -
2001.100.5.32
C -
201.100.5.64
D -
201.100.5.65
8-
Which devices can be used to segment a network?
A -
Switch
B -
Bridge
C -
Router
D -
All of them
9-
Which WAN service would a small office (SOHO) most likely choose as a backup for leased lines?
A -
Frame relay with svc
B -
Dedicated serial line
C -
Isdn with ddr
D -
Atm
10-
What is the effect of the following access list condition?
access.list 101 permit ip 10.25.30.0 0.0.0.255 any
A -
Permit all packets matching the first three octets of the source address to all destinations.
B -
Permit all packets matching the last of the destination address and accept all source address.
C -
Permit all packets from the third subnet of the network address to all destinations.
D -
Permit all packets matching the host bits in the source address to all destinations.