You have just entered the command copy running-config startup-config command to save your
configuration so that if the router is rebooted it will keep your configuration. Which type of router
memory normally stores the startup configuration?
A -
RAM
B -
ROM
C -
FLASH
D -
NVRAM
2-
You have hired a new consultant to help you setup and configure a router in the Florida office. You are
located in the company headquarters in Atlanta from the DOS command prompt, you are able to ping a
router but are unable to telnet it. What is most likely causing this problem?
A -
The PC has a bad network interface card.
B -
The IP address of the router is on a different subnet.
C -
No password has been set on the router vty lines.
D -
The default gateway is not set on the PC.
3-
Management has reported that they cannot access the corporate files on the companys ftp server from
home. They were able to do this in the past. You feel that somebody has changed an access list that is
preventing those managers from accessing the corporate data. The access list number is 131. Which
command displays access list 131?
A -
Show access-list 131
B -
Show IP access list 131
C -
Display IP address list 131
D -
Display access-list 131 details
4-
You have a direct serial link to an adjacent router. You do not have connectivity, and when you run the
show running-config the output says that the serial interface is shutdown.
You issue the command: show interface s0
What will the output include?
A -
Serial 0 is up, line protocol is down.
B -
Serial 0 is down, line protocol is down.
C -
Serial 0 is down, line protocol is up.
D -
Serial is administratively down, line protocol is down.
5-
RouterC does not appear to be receiving RIP updates from RouterB, which command can you enter on
RouterC to see if it is receiving these RIP updates?
A -
Show ip protocols.
B -
Show ip route rip.
C -
Debug ip rip.
D -
Debug ip updates.
6-
Which one of the following cables allows a router to another router over the Ethernet? This is a direct
connection and not using a hub or a switch.
A -
Cable A
B -
Cable B
C -
Cable C
D -
Cable D
7-
To configure and apply a standard access list on an interface which two of the following are required?
A -
Define and access list number and its parameter.
B -
Enable an interface to become part of the access list group.
C -
Define the number of access list to be supported on an interface.
D -
Both A & B
8-
Which one of the following commands below is an example of a hybrid routing protocol?
A -
Router ospf 1
B -
Router eigrp 100
C -
Router igrp 100
D -
Router rip
9-
In troubleshooting an Internetwork which of the following commands are usually used?
A -
Ping
B -
Trace
C -
Verify
D -
Both A & B
10-
802.3 Ethernet networks use (CSMA/CD). This means that multiple stations have access to media , and
before one station can access that media, it must first "listen" (carrier sense) to make sure no other
station using the same media. If two stations transmit at the same time, the result is a collision. If this
happens a back off algorithm is used. What is this back off algorithm used for?
A -
It is latency stored and forward switching.
B -
It is the time used to token passing from machine to machine.
C -
It is re transmission delay that is encountered when a collision occurs.
D -
It the result of two nodes transmitting at the same time the frames from each transmitting device collide and are damaged.