You would like to configure IP RIP on your Cisco Router. Which of the following steps below are
required to install IP RIP?
A -
Specify the routing protocol.
B -
Configure static Rip routes.
C -
Specify directly connected subnets.
D -
All of the above
2-
Billy was hired to setup Frame Relay subinterfaces on a point-point connection between two routers.
Which of the following should Billy take into consideration when setting up this connection?
A -
Remove any network address assigned to the physical interface.
B -
Configure the router to forward all broadcast packets.
C -
Partition the total committed information rate available among the subinterfaces.
D -
Both B & C
3-
The Internet Control Message Protocol (ICMP) is implemented by all TCP/IP hosts. Which of the
following demonstrate the functions of the ICMP Protocol?
A -
To send a host or post unreachable message from a router to the source of an undeliverable packet.
B -
To generate an echo reply in response to a ping test.
C -
To map common names to network addresses.
D -
Both A & B
4-
In todays networks which encapsulation methods are most commonly used (ISDN)?
A -
PPP and SDLC
B -
PPP and HDLC
C -
IP and PPP
D -
IP and IPX
5-
You are configuring a PPP CHAP connection between two routers. The hostnames are SNOWBALL1
and SNOWBALL2. The SNOWBALL1 router has already been configured. You are responsible for
configuring SNOWBALL2. The password configured on SNOWBALL1 is cisco. Which of the following
is the correct username syntax that you will need to configure on SNOWBALL2?
A -
Username SNOWBALL2 password cisco
B -
Username SNOWBALL2 password SNOWBALL1
C -
Username SNOWBALL1 password cisco
D -
Username SNOWBALL1 password SNOWBALL2
6-
Point-to-Point protocol (PPP) is used as a WAN encapsulation between two routers. Which one of the
following is true regarding PPP?
A -
PPP supports TCP/IP, but not Novell IPX.
B -
PPP is being phased out of existence by the Serial Line Internet protocol.
C -
PPP provides router-to-router and host-to-network connections over both synchronous and asynchronous circuits.
D -
PPP is an ITU-T and ANSI standard that defines the process for sending data over a packet-switched data network.
7-
A Novell IPX address has 80 bits. 32 bits for the network number and 48 bits for the node number.
How is the node number determined?
A -
It is the serial number of the given device.
B -
It is assigned as a lease by Novell DHCP.
C -
It is also set by the network administrator.
D -
It is usually the MAC address of one interface.
8-
Which two statements about a Layer 2 bridge are true?
A -
A bridge does not flood broadcasts.
B -
A bridge does not flood multicasts.
C -
A bridge floods broadcasts.
D -
Both A & B
9-
What are two commands that you can use to view your access lists?
A -
Show filters.
B -
Show access-lists.
C -
Show IP access-list.
D -
Both B & C
10-
Which IP address range is allowable given an IP address of 131.107.2.56 and 28-bits of subnetting?