What is the function of the command switchport trunk native vlan 999 on a Cisco Catalyst switch?
A -
It designates VLAN 999 for untagged traffic.
B -
It blocks VLAN 999 traffic from passing on the trunk
C -
It creates a VLAN 999 interface.
D -
It designates VLAN 999 as the default for all unknown tagged traffic.
2-
Which one statements about static NAT translation are true?
A -
They allow connections to be initiated from the outside.
B -
They require no inside or outside interface markings because addresses are statically defined.
C -
They can be configured with access lists, to allow two or more connections to be initiated from the outside.
D -
All of the above.
3-
Which command is used to display the collection of OSPF link states?
A -
show ip ospf neighbors
B -
show ip ospf database
C -
show ip ospf link-state
D -
show ip ospf Isa database
4-
How are VTP advertisements delivered to switches across the network?
A -
unicast frames
B -
multicast frames
C -
broadcast frames
D -
anycast frames
5-
Refer to the exhibit.
The VLAN configuration of S1 is not being updated in this VTP-enabled environment. The VTP
and uplink port configuration for each switch are displayed. Which two command sets, if issued,
resolve this failure and allow VTP to operate as expected?
An attempt to deny web access to a subnet blocks all traffic from the subnet. Which interface
command immediately removes the effect of ACL 102?
A -
no ip access-class 102 out
B -
no ip access-group 102 out
C -
no ip access-group 102 in
D -
no ip access-list 102 in
7-
Which pairing reflects a correct protocol-and-metric relationship?
A -
EIGRP and link cost
B -
OSPF and number of hops and reliability
C -
RIPv2 and number of hops
D -
IS-IS and delay and reliability
8-
Which term describes a spanning-tree network that has all switch ports in either the blocking or forwarding state?
A -
spanned
B -
converged
C -
provisioned
D -
redundant
9-
Refer to the exhibit.
The EIGRP configuration in the router uses a single network statement. From the output shown in
the graphic, which network statement would advertise these networks in EIGRP?
A -
network 172.26.168.128 area 478
B -
network 172.26.168.128 0.0.0.127
C -
network 172.26.168.0 area 478
D -
network 172.26.0.0
10-
Refer to the exhibit.
What is the result of setting the no login command?
A -
Telnet access is denied.
B -
Telnet access requires a new password at the first login.
C -
Telnet access requires a new password.
D -
There is a virtually limitless supply of IP addresses.