Which two benefits can be obtained by using VTP in a switching environment?
A -
Allowing switches to read frame tags.
B -
Maintaining VLAN consistency across a switched network.
C -
Allowing VLAN information to be automatically propagated throughout the switching environment.
D -
Both B & C
2-
Which two statements are true about the command ip route 172.16.3.0 255.255.255.0
192.168.2.4?
A -
It configures the router to send any traffic for an unknown destination to the 172.16.3.0 network.
B -
It creates a static route to the 192.168.2.0 network.
C -
It uses the default administrative distance.
D -
It configures the router to send any traffic for an unknown destination out the interface with the address 192.168.2.4.
3-
Which two of the following are advantages of Layer 2 Ethernet switches over hubs?
A -
To increase the size of broadcast domains
B -
To filter frames according to MAC addresses
C -
To allow simultaneous frame transmissions
D -
To increase the maximum length of UTP cabling between devices
4-
Refer to the exhibit. A network associate needs to configure the switches and router in the graphic
so that the hosts in VLAN3 and VLAN4 can communicate with the enterprise server in VLAN2.
Which two Ethernet segments would need to be configured as trunk links?
A -
A
B -
B
C -
C
D -
D
5-
Which two values are used by Spanning Tree Protocol to elect a root bridge?
A -
IP address
B -
MAC address
C -
IOS version
D -
amount of RAM
6-
Refer to the exhibit. Assume that the routing protocol referenced in each choice below is
configured with its default settings and the given routing protocol is running on all the routers.
Which two conditional statements accurately state the path that will be chosen between networks
10.1.0.0 and 10.3.2.0 for the routing protocol mentioned?
A -
If OSPF is the routing protocol, the path will be from R1 to R3 to R4 to R5.
B -
If OSPF is the routing protocol, the path will be from R1 to R2 to R5.
C -
If OSPF is the routing protocol, the path will be from R1 to R5.
D -
If RIPv2 is the routing protocol, the path will be from R1 to R3 to R4 to R5.
7-
Refer to the exhibit. A network administrator is adding two new hosts to SwitchA. Which three
values could be used for the configuration of these hosts?
A -
host A IP address: 192.168.1.79
B -
host A default gateway: 192.168.1.78
C -
host B IP address: 192.168.1.190
D -
All of the above
8-
What will happen after changing the configuration register to 0x2142 and rebooting the router?
A -
The IOS image will be ignored.
B -
The router will prompt to enter initial configuration mode.
C -
The router will boot to ROM.
D -
The configuration in flash memory will be booted.
9-
Refer to the exhibit. The networks connected to router R2 have been summarized as a
192.168.176.0/21 route and sent to R1. Which two packet destination addresses will R1 forward to
R2?
A -
192.168.194.160
B -
192.168.183.41
C -
192.168.159.2
D -
192.168.183.255
10-
Which three statements are typical characteristics of VLAN arrangements?
A -
Connectivity between VLANs requires a Layer 3 device.
B -
Each VLAN uses a separate address space.
C -
A switch maintains a separate bridging table for each VLAN.