Which IPV6 routing protocol uses multicast group FF02::9 to send updates?
A -
RIPng
B -
OSPFv3
C -
static
D -
IS-IS for Ipv6
2-
What is one benefits of using NAT?
A -
NAT protects network security because private networks are not advertised.
B -
NAT accelerates the routing process because no modifications are made on the packets.
C -
Dynamic NAT facilitates connections from the outside of the network.
D -
NAT facilitates end-to-end communication when IPsec is enable.
3-
A switch is configured as a vtp sever with a domain name of CCNA. Which cisco ios privileged
mode command,followed by a reload of the switch, will reset the VTP management domain name
of the switch to a NULL value?
A -
#vtp domain unset
B -
#delete vlan.dat
C -
#no vtp domain
D -
#vtp domain null
4-
If an Ethernet port on a router was assigned an IP address of 172.1.1.1/20, what is the maximum
number of hosts allowed on this subnet?
A -
4094
B -
8190
C -
2046
D -
4096
5-
Which one statements about static NAT translations is true?
A -
They can be configured with access lists, to allow two or more connections to be initiated from the outside.
B -
They allow connection to be initiated from the outside.
C -
They require no inside or outside interface markings because addresses are statically defined.
D -
All of the above.
6-
Which of these represents an IPv6 link-local address?
A -
FE08::280e:611:a:f14f:3d69
B -
FE81::280f:512b:e14f:3d69
C -
FE80::380e:611a:e14f:3d69
D -
FEFE:0345:5f1b::e14d:3d69
7-
Assuming default setting,how can you erase the VTP database of VLANs on a CISCO IOS switch
running in VTP server mode?
A -
Enable VTP pruning
B -
From privileged mode ,erase the startup configuration file,then reload.
C -
From privileged mode ,erase the vlan date file, then reload.
D -
Cycle the switch power.
8-
Refer to the exhibit. Which address and mask combination represents a summary of the routes
learned by EIGRP?
A -
192.168.25.16 255.255.255.252
B -
192.168.25.0 255.255.255.252
C -
192.168.25.28 255.255.255.240
D -
192.168.25.16 255.255.255.240
9-
Refer to the exhibit:
A frame on vlan 1on switch s1 is sent to switch s2 when the frame is received on vlan 2, what
causes this behavior?
A -
trunk mode mismatches
B -
vlans that do not correspond to a unique IP subnet
C -
native vlan mismatches
D -
allowing only vlan 2 on the destination.
10-
Refer to the exhibit.
The network administrator normally establishes a Telnet session with the switch from host A.
However, host A is unavailable. The administrator's attempt to telnet to the switch from host B
fails, but pings to the other two hosts are successful. What is the issue?
A -
Host B and the switch need to be in the same subnet.
B -
The switch needs an appropriate default gateway assigned.
C -
The switch interface connected to the router is down.
D -
Host B needs to be assigned an IP address in vlan 1.